英文資料

日本語資料

ARMDテクニカルニュース

1

Kirchhoff, G., Vorlesungen uber Mathematische Physik, Vol. 1, Mechanik 1876.

2

Palmgren, A., "Die Lebensdauer Von Kugellagern," Z. Vereines Deutscher Ingenieure, 68 (1925).

3

N.O. Myklestad, Journal of Aeronautical Sciences, Vol. 11, 1944 pp. 153.

4

Miner, M. A., "Cumulative Damage in Fatigue," J. Appl. Mech., Sept. 1945.

5

M.A. Prohl, "A General Method for Calculating Critical Speeds of Flexible Rotors", Journal of applied Mechanics, Vol. 12, 1945, pp. 142-148.

6

Sachs, F. and Bouche, Ch., eds., Dubbel's Taschenbuch Fur den Maschinenbau, Spring, 1953.

7

Timoshenko, S., "Vibration Problems in Engineering", D. Van Nostrand Company, 3rd Edition, 1955.

8

Wilson, W. Ker, "Practical Solution of Torsional Vibration Problems," Vol. I, II, Chapman & Hall, 1956.

9

A Handbook on Torsional Vibration, compiled by E. J. Nestorides of the B.I.C.E.R.A. Research Lab., Cambridge Press, 1957.

10

11/Newmark, N. M., "A Method of Computation for Structural Dynamics," Proc. ASCE, J. of Eng. Mech., July 1959.

11

J.W. Lund and B. Sternlicht, "Rotor-Bearing Dynamics with Emphasis on Attenuation", Journal of Basic Engineering, TRANS. ASME, Vol. 84, Series D, December 1962, pp. 491-502.

12

Przemieniecki, J. S., 'Theory Of Matrix Structural Analysis', McGraw-Hill Book Company, New York, 1963.

13

Agyris, H. H., 'Recent Advances in Matrix Methods of Structural Analysis', The MacMillan Co, New York, 1964.

14

Jones, A. B., "The Mathematical Theory of Rolling Element Bearings", Chapter 13 of "Mechanical Design and Systems Handbook", McGrow Hill, Rothbart as Editor, 1964, New York, New York.

15

Wilkinson, J. H., 'The Algebraic Eignvalue problem', Clarendon Press, Oxford England, 1965.

16

Gunter, E. J., "Dynamic Stability of Rotor Bearing Systems", NASA SP-113, Washington, D.C., NASA 1966.

17

Castelli. V.; Shapiro, W., "Improved Method of Numerical Solution of the General Incompressible Fluid-Film Lubrication Problem", Transactions ASME, Journal Of Lubrication Technology, April 1967, pg. 211-218.

18

H. G. Elrod, Jr.; C. W. Ng., "A Theory for Turbulent Fluid Films and Its Application to Bearings", Trans. ASME, Journal of Lubrication Technology, Vol. 89, Series F, No. 3, July 1967, pp. 346-362.

19

H. C. Rippel, "Cast Bronze Thrust Bearing Design Manual", July 1967, Published by CAST BRONZE BEARING INSTITUTE, INC.

20

H. C. Rippel, "Cast Bronze Hydrostatic Bearing Design Manual", Second Edition, Third Printing, July 1969, Published by CAST BRONZE BEARING INSTITUTE, INC.

21

H. C. Rippel, "Cast Bronze Bearing Design Manual", Second Edition, Fourth Printing, July 1971, Published by CAST BRONZE BEARING INSTITUTE, INC.

22

Military Standardization Handbook of Materials and Elements for Aerospace Structures, MIL-HDBK-5B, 1971.

23

Mruk, G., Halloran, J. and Kolodziej, R., "Torsional Response of a Compressor shaft Systems During Synchronous Startup, Part I - Analytical Model", ASME Paper 77-Pet-49

24

Shapiro, W.; Colsher R., "Dynamic Characteristics of Fluid-Film Bearings", Proceedings of the Sixth Turbomachinery Symposium, Sponsored by, Gas Turbine Laboratories, Texas A&M University, December 1977.

25

Anwar, I., Colsher, R., "Computerized Time Transient Torsional Analysis of Power Trains" An ASME Publication, Design Engineering Division 79-DET-74. September 1979.

26

R. Colsher, I. Anwar, V. Obeid,"NON-LINEAR BEARING EFFECTS ON ROTOR DYNAMIC ANALYSIS", ASME Paper 82-GT-291.

27

Colsher R., Anwar I., Katsumata S., "Computer Aided Design Of Fluid-Film Bearings", presented at ASME-ASLE Lubrication Conference, October 5-7, 1982, Washington, D. C.

28

I. Anwar, R. Colsher, V. Obeid, "INFLUENCE OF WEAR-RINGS ON STABILITY AND CRITICAL SPEED OF BOILER FEED PUMP", ASME Paper 83-DET-99.

29

J. W. Spencer, V. K. Obeid, "CORRECTION OF COMPRESSOR CRITICAL SPEED CONDITION THROUGH FLUID-FILM BEARING OPTIMIZATION", ASME Mechanical Vibration and Noise conference December 1985, Cincinnati, Ohio.

30

V. K. Obeid, "ROTOR DYNAMIC ANALYSIS ON PERSONAL COMPUTERS", ASME Mechanical Vibration and Noise Conference September 1987, Boston, Massachusetts.

31

V. N. Constantinescu, "Lubrication in Turbulent Regime", U.S. Atomic Energy Commission, Division of Technical Information, Available as AEC-tr-6959 from Clearinghouse for Federal Scientific and Technical Information, National Bureau of Standards, U.S. Department of Commerce, Springfield, Virginia 22151.

32

杉村章二郎；振動事例から見たガスタービン振動設計；日本ガスタービン学会誌 Vol.33 No.1, P32-37, 2005-01-20

33

Sugimura, S., et. al., "The Rotor Dynamic Design of High-speed Generator Unit Driven through the Shaft End of Turbocharger", Proc. IGTC 2007 Tokyo, Dec. 3-7, 2007